Printing And Checking The Printer Settings Page - Dell 3130cn - Color Laser Printer User Manual

NOTE: This step may not be necessary if you have Windows XP Service Pack 2 installed.
If your printer is connected directly to a network and the Windows 7, Windows Vista, Windows Server 2008 R2, Windows
Server 2008, or Windows XP firewall is enabled, you cannot view your networked printer(s) when you run the Dell™
printer installation software. To prevent this situation, disable the Windows 7, Windows Vista, Windows Server 2008 R2,
Windows Server 2008, or Windows XP firewall before you install the Dell printer software. To disable or enable your
Windows 7, Windows Vista, Windows Server 2008 R2, Windows Server 2008, or Windows XP firewall, perform the
following steps.
NOTICE: It is recommended that you enable your Windows 7, Windows Vista, Windows Server 2008 R2, Windows
Server 2008, or Windows XP firewall after you install the printer software. Enabling the Windows 7, Windows Vista,
Windows Server 2008 R2, Windows Server 2008, or Windows XP firewall after you install the printer software does
not limit the use of your printer.
1. Click the start button and click Help and Support.
NOTE: For Windows Server 2008 R2 and Windows 7, if you use Online Help, switch to Offline Help on
Windows Help and Support window.
2. In the Search box, type firewall and then press Enter.
In the list, click Turn Windows Firewall on or off and then follow the instructions on the screen.

Printing and Checking the Printer Settings Page

Before installing the printer driver on your computer, print the printer settings page to check your printer's IP address.
When Using the Operator Panel
1. Press Menu button.
2. Press button until Report/List appears, and then press
3. Printer Setting is displayed, and then Press
The printer settings page is printed.
4. Look under the TCP/IP heading on the printer settings page.
If the IP address is 0.0.0.0, wait for a few minutes to resolve the IP address automatically, and then print the
printer settings page again.
If the IP address is not resolved automatically, refer to
Local Network Printer Setup
1. Insert the Drivers and Utilities CD into your computer to start Easy Setup Navigator.
NOTE: If the CD does not automatically launch, click start® All Programs (for Windows Vista and Windows
7)® Accessories (for Windows Vista and Windows 7)® Run, and then type D:\setup_assist.exe (where D
is the drive letter of your CD), and then click OK.
2. Press Software Installation to launch the installation software.
3. Select Network Installation, and then click Next.
4. Select Local Installation, and then click Next.
(Set) button.
(Set) button.
"Assign an IP Address".