Configure And Enable Ethernet Events - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

3. Enter the IP address or DNS host name of the SMTP server in the E-mail
4. Enter the e-mail address to which e-mail replies should be sent in the Reply
5. At the Interval field, type the length of time the application should wait
6. To configure event types for which e-mail notification is sent, select (click)
Note:
Switch 2/24 Element Manager application. E-mail notification can be active for some
switches and inactive for others.
7. Click OK to save the information and close the dialog box.
8. Click Test E-mail. A test message is sent to configured e-mail recipients.
9. Click OK to save the information and close the E-mail Event Notification
10. At the Hardware View page for the selected switch, choose Maintenance >

Configure and Enable Ethernet Events

Perform this procedure to configure and enable Ethernet events. An Ethernet
event is recorded (after a user-specified time interval) when the switch-to-HAFM
appliance communication link drops. To configure and enable Ethernet events:
1. Minimize the Hardware View and return to the HAFM application.
2. At the HAFM or EWS main window, select the Monitor > Ethernet Event.
Edge Switch 2/24 Installation Guide
Server field. Use 64 or fewer alphanumeric characters. It is recommended
that the IP address be used.
field.
between notifications. Choose seconds, minutes, or hours from the associated
drop-down list.
the Filter link adjacent to the check box. The Define Filter dialog box
displays. For instructions on defining event filters, refer to the HP
StorageWorks Edge Switch 2/24 Element Manager User Guide.
The enable function must also be activated for each switch through the Edge
Setup dialog box.
Enable E-Mail Notification. A check mark displays in the check box to
indicate e-mail notification for the switch is enabled, and the menu closes.
The Configure Ethernet Events dialog box displays
Installing and Configuring the Edge Switch 2/24
(Figure 25).
79