Rack Mount Checklist; Mounting Hardware; Brackets And Rails - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Rack Mount Instructions

Rack Mount Checklist

This section describes the contents of the rack mount kit as well as tools or
equipment required to complete the installation.
Note:
these instructions.

Mounting Hardware

Brackets and Rails

Brackets and rails included in the kit are shown in
1 Two (2) fixed-length slide rails (one left and one right)
2 Two (2) Front brackets
3 Two (2) Rear brackets (long)
4 Two (2) Rear spacing bracket
5 Rear bracket (short)–not used in this configuration
40
The hardware kit includes parts not required for the configuration described in
Two (2) two-hole bar nuts
Six (6) three-hole bar nuts (only 4 used)
Eight (8) square alignment washers (required only for HP 9000, 10000 and
11000 series racks)
Eight (8) Phillips panhead screws (10-32 x 1/2) with split lock and flat
washers
Four (4) Phillips flathead screws (8-32 x 7/16)
Ten (10) Phillips panhead screws (10-32 x 5/8) with flat washer (only 2 used)
Six (6) Phillips flathead screws (6-32 x 3/8) (not used)
Twelve (12) Phillips panhead screws (10-32 x 3/8) (not used)
Four (4) 8-32 Keps nuts (not used)
Figure 5.
Edge Switch 2/24 Installation Guide