Installing The Switch In The Cabinet - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Installing the Switch in the Cabinet

Use these steps to install the switch in the cabinet. You will need a #2 Phillips
screwdriver and two rear spacing brackets to complete this procedure.
1. From the front side of the cabinet, slide the switch into the mounting brackets
2. Bring the rear spacing brackets to the rear of the cabinet.
3. Pull the switch toward the rear of the cabinet until it protrudes approximately
4. Orient the rear spacing bracket mounts so that they are pointed outward. Insert
5. Push the switch forward using both rear spacing brackets until the rear
6. Attach the rear spacing brackets to the cabinet using two Phillips panhead
7. Ensuring that the square alignment washers are seated properly within the
Edge Switch 2/24 Installation Guide
and along the rails until the rear of the switch is flush with the rear of the
cabinet.
3 inches.
the tabs on each rear spacing bracket into the designated slots in each rail.
spacing bracket mounts contact the cabinet rail.
screws (10-32 x 5/8) with flat washer.
square cabinet frame holes, use a Phillips head screwdriver to tighten the rear
and front mounting screws.
Rack Mount Instructions
45