Connection Description Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Installing and Configuring the Edge Switch 2/24
Perform the following steps to change a switch's IP address, subnet mask, or
gateway address:
1. Remove the protective plastic cover from the 9-pin maintenance port at the
2. Connect the other cable end to a 9-pin communication port (COM1 or
3. Power on the maintenance terminal. After the PC powers on, the Windows
Note:
communication software are described in
4. Choose Start > Programs > Accessories > Communications >
Figure 7: Connection Description dialog box
54
— RS-232 serial communication software (for example, ProComm Plus or
HyperTerminal).
Note that the HAFM appliance may be used for this function and that
HyperTerminal is included in the Windows operating system provided in the
HAFM appliance.
An asynchronous RS-232 null modem cable (provided with the switch).
rear of the switch (a phillips-tip screwdriver is required). Connect the 9-pin
end of the RS-232 null modem cable to the port.
COM2) at the rear of the maintenance terminal PC.
desktop displays. Refer to operating instructions shipped with the PC.
Procedures for changing network addresses using the HyperTerminal serial
HyperTerminal. The Connection Description dialog box displays,
(Figure 7).
step 4 through step 13.
Edge Switch 2/24 Installation Guide