Installing The Edge Switch In A Rack; Rack Mount Checklist; Mounting Hardware - HP StorageWorks Edge Switch 2/12 Installation Manual

WARNING!
prevent electric shock when connecting the Edge Switch to primary facility power, use only the
supplied power cords, and ensure that the facility power receptacle is the correct type, supplies the
required voltage, and is properly grounded.
6. Connect the remaining end of the AC power cord to a power source that provides single-phase,
120 to 240 volt alternating current (VAC).
7. Turn on the power.
The unit powers on and performs power-on self-tests (POSTs). During POSTs:
• The green power (PWR) LED on the front panel turns on.
• The amber system error (ERR) LED on the front panel flashes momentarily while the Edge
Switch is tested.
• The green LEDs associated with the Ethernet port flash momentarily while the port is tested.
• The green/blue and amber LEDs associated with the ports flash momentarily while the ports
are tested.
After successful POST completion, the green power (PWR) LED remains on and all other front
panel LEDs turn off.
8. If a POST error or other malfunction occurs, see the Edge Switch service manual to isolate the
problem.

Installing the Edge Switch in a rack

This section describes how to mount the Edge Switch in one of the following rack types:
• HP 9000 series, 10000 series, or 11000 series
• HP rack system/e or 19-inch EIA

Rack mount checklist

This section describes the contents of the rack mount kit as well as tools or equipment required to
complete the installation.
NOTE: The hardware kit includes parts not required for the configuration described in these
instructions.

Mounting hardware

• Two two-hole bar nuts
• Six three-hole bar nuts (only four used)
• Eight square alignment washers (required only for HP 9000, 10000 and 11000 series racks)
• Eight Phillips panhead screws (10-32 x 1/2) with split lock and flat washers
• Four Phillips flathead screws (8-32 x 7/16)
An HP-supplied power cord is provided for each Edge Switch power supply. To
Edge Switch 2/12 installation guide 23