Install the Edge Switch in a Rack
This section describes how to rack mount the HP StorageWorks Edge Switch 2/32 in the
appropriate HP, or comparable, 19-inch Electronic Industries Association (EIA) rack:
HP 9000 series, 10000 series and 11000 series racks
•
•
HP rack system/e or 19-inch EIA rack
Rack mount checklist
This section describes the contents of the rack mount kit as well as tools or equipment required to
complete the installation.
NOTE:
The hardware kit includes parts not required for the configuration described in these
instructions.
Mounting hardware
•
Two (2) two-hole bar nuts
•
Six (6) three-hole bar nuts (only 4 used)
•
Eight (8) square alignment washers (required only for HP 9000, 10000 and 11000 series
racks)
•
Eight (8) Phillips panhead screws (10-32 x 1/2) with split lock and flat washers
•
Four (4) Phillips flathead screws (8-32 x 7/16)
•
Ten (10) Phillips panhead screws (10-32 x 5/8) with flat washer (only 2 used)
•
Six (6) Phillips flathead screws (6-32 x 3/8) (not used)
•
Twelve (12) Phillips panhead screws (10-32 x 3/8) (not used)
•
Four (4) 8-32 Keps nuts (not used)
Brackets and rails
Brackets and rails included in the kit are shown in
1 Two (2) fixed-length slide rails (one left and one right)
2 Two (2) Front brackets
3 Two (2) Rear brackets (long)
4 Two (2) Rear spacing bracket
26
Installing and configuring the Edge Switch 2/32
Figure
6.