Installation Instructions; Edge Switch Rack Mount Kit Checklist; Mounting Hardware - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Instructions Manual

Read these instructions to rack mount the HP StorageWorks Edge Switch 2/24 in the
appropriate HP, or comparable, 19-inch Electronic Industries Association (EIA) rack:
• HP 9000 series, 10000 series and 11000 series racks
• HP rack system/e or 19-inch EIA rack

Edge Switch Rack Mount Kit Checklist

The hardware kit includes parts not required for the configuration described in these
instructions.

Mounting Hardware

• Two (2) two-hole bar nuts
• Six (6) three-hole bar nuts (only 4 used)
• Eight (8) square alignment washers (required only for HP 9000, 10000 and 11000
series racks)
• Eight (8) Phillips panhead screws (10-32 x 1/2) with split lock and flat washers
• Four (4) Phillips flathead screws (8-32 x 7/16)
• Ten (10) Phillips panhead screws (10-32 x 5/8) with flat washer (only 2 used)
• Six (6) Phillips flathead screws (6-32 x 3/8) (not used)
• Twelve (12) Phillips panhead screws (10-32 x 3/8) (not used)
• Four (4) 8-32 Keps nuts (not used)
edge switch 2/24 rack mount kit installation instructions

Installation Instructions

1