Installing The San Switch 2/32 In An Hp Series 9000 Or Eia Cabinet; Rack Mount Checklist - HP StorageWorks 2/32 - SAN Switch Installation Manual

Installing the SAN Switch 2/32 in an HP Series 9000
or EIA Cabinet
Read the following sections for complete installation instructions. Before you
begin, obtain the following tools:

Rack Mount Checklist

Verify that the rack and the area around the rack meets the following
requirements:
Note:
which contains the air intake vents, is installed facing the cool-air aisle.
SAN Switch 2/32 Installation Guide
#2 Phillips screwdriver, with torque capability
Torx screwdriver
Slotted blade screwdriver, 1/4 inch, with torque capability
The cabinet must be a standard EIA cabinet.
Plan a cabinet space that is 1.5 rack units high (2.6 inches; 6.7 cm), 19 inches
(48.3 cm) wide, and at least 23 inches (68.6 cm) deep.
Ground all equipment in the cabinet through a reliable branch circuit
connection, and maintain ground at all times. Do not rely on a secondary
connection to a branch circuit, such as a power strip.
Ensure that airflow and temperature requirements are met on an ongoing
basis, particularly if the switch is installed in a closed or multi-rack assembly.
Verify that the additional weight of the switch does not exceed the cabinet's
weight limits or unbalance the cabinet in any way.
Secure the cabinet to insure stability in case of unexpected movement.
This procedure is written with the assumption that the non-port side of the switch,
Installing the SAN Switch 2/32
31