Install The Edge Switch In A Rack; Rack Mount Checklist; Mounting Hardware; Brackets And Rails - HP StorageWorks Edge Switch 2/12 Installation Manual

Install the Edge Switch in a Rack

This section describes how to mount the HP StorageWorks Edge Switch 2/12 in a
standard HP rack.

Rack Mount Checklist

This section describes the contents of the rack mount kit as well as tools or
equipment required to complete the installation.
Note:
these instructions.

Mounting Hardware

Brackets and Rails

Brackets and rails included in the kit are shown in
1 Two (2) fixed-length slide rails (one left and one right)
2 Two (2) Front brackets
3 Two (2) Rear brackets (long)
4 Two (2) Rear spacing bracket
5 Rear bracket (short)–not used in this configuration
Edge Switch 2/12 Installation Guide
The hardware kit includes parts not required for the configuration described in
Four (4) two-hole bar nuts
Six (6) three-hole bar nuts (only 4 used)
Eight (8) square alignment washers (required only for HP 9000, 10000, and
11000 series racks)
Eight (8) Phillips panhead screws (10-32 x 1/2) with split lock and flat
washers
Eight (8) Phillips flathead screws (8-32 x 7/16)
Ten (10) Phillips panhead screws (10-32 x 5/8) with flat washer (only 2 used)
Six (6) Phillips flathead screws (6-32 x 3/8) (not used)
Twelve (12) Phillips panhead screws (10-32 x 3/8) (not used)
Four (4) 8-32 Keps nuts (not used)
Installing and Configuring the Edge Switch 2/12
Figure 4 on page 36:
35