Ident Function - Garmin G1000H Pilot's Manual
Integrated flight deck pilot’s guide for the bell 407gx
Hide thumbs
Also See for G1000H:
- Cockpit reference manual (136 pages) ,
- Cockpit reference manual (158 pages)
Table of Contents
Advertisement
AUDIO PANEL AND CNS
VFR CODE
The VFR code can be entered either manually or by pressing the XPDR Softkey, then the VFR Softkey.
When the VFR Softkey is pressed, the pre-programmed VFR code is automatically displayed in the code field
of the Transponder Data Box. Pressing the VFR Softkey again restores the previous identification code.
The pre-programmed VFR Code is set at the factory to 1200. If a VFR code change is required, contact a
Garmin-authorized service center for configuration.
IDENT FUNCTION
In Standby Mode, the IDENT Softkey is inoperative.
NOTE:
Pressing the IDENT Softkey sends a distinct identity indication to Air Traffic Control (ATC). The indication
distinguishes the identing transponder from all the others on the air traffic controller' s screen. The IDENT
Softkey appears on all levels of transponder softkeys. When the IDENT Softkey is pressed, a green IDNT
indication is displayed in the mode field of the Transponder Data Box for a duration of 18 seconds.
After the IDENT Softkey is pressed while in Mode or Code Selection, the system reverts to the top-level
softkeys.
Press the IDENT
Softkey to Initiate
the ID Function
122
Figure 4-38 VFR Code
Figure 4-39 IDENT Softkey and Indication
Garmin G1000H
Pilot's Guide for the Bell 407GX
™
VFR Code
IDNT
Indication
190-01255-00 Rev. A
Advertisement
Table of Contents
