Garmin G1000H Pilot's Manual page 517

5) Acknowledge the Power-up Page agreement by pressing the ENT Key or the right most softkey.
6) Turn the large FMS Knob to select the AUX Page group on the MFD.
7) Turn the small FMS Knob to select the System Status Page.
8) Monitor the Sync Status in the Database Window. Wait for all databases to complete synching, indicated by
'Complete' being displayed as seen in Figure B-9.
9) Remove and reapply power to the system.
10) Turn the large FMS Knob to select the AUX Page group on the MFD.
11) Turn the small FMS Knob to select the System Status Page.
12) Press the Display Database Selection Softkey to show database information for each display (MFD1 DB, PFD1
DB). Verify the correct database cycle information is shown for each database for each display.
190-01255-00 Rev. A
Figure B-10 Database Information on the Power-up Screen
Unselected MFD1 DB Selected PFD1 DB Selected
Figure B-11 Display Database Softkey
Garmin G1000H ™ Pilot's Guide for the Bell 407GX
APPENDIX B
505