Garmin G1000H Pilot's Manual page 354

HAZARD AVOIDANCE
ALTITUDE VOICE CALLOUT (VCO) AURAL ALERTS
HTAWS provides aural altitude advisory alerts as the aircraft descends. VCO alerts are based on either radar
altitude (if a radar altimeter is installed and available) or the GPS-computed height above terrain.
A VCO alert consists of a aural message such as "five hundred".
VCO alerts can be configured to occur at altitudes of 500', 400', 300', 200', 150' and 50'; alerts may also be
disabled entirely. There are no display annunciations or pop-up alerts that accompany the aural VCO alert(s).
Configuring VCO alerting altitudes:
1) Turn the large FMS knob to select the AUX - System Setup Page.
2) If the Aux - System Setup 2 Page is not already displayed, press the SETUP 2 Softkey.
3) Press the FMS Knob to activate the cursor.
4) Turn the large FMS Knob to highlight the altitude shown in the MAX SELECTED field.
5) Turn the small FMS Knob to select the maximum altitude at which VCO alerts will be enabled from (from 500
to 50 feet), or select NONE to disable all VCO alerts.
6) When finished, press the FMS Knob.
The G1000H remembers the VCO alert altitude configuration through power cycles.
342
Figure 6-82 Voice Callout Settings
(AUX - System Setup 2 Page)
Garmin G1000H Pilot's Guide for the Bell 407GX
™
190-01255-00 Rev. A