Garmin G1000H Pilot's Manual page 47

5) Turn the large FMS Knob to select the ON/OFF field in the Arrival Alert Box.
6) Turn the small FMS Knob clockwise to turn the airspace alert ON or counterclockwise to turn the alert OFF.
7) Press the FMS Knob to deactivate the cursor.
Changing the arrival alert trigger distance:
1) Turn the large FMS Knob to select the AUX Page group.
2) Turn the small FMS Knob to select System Setup.
3) If necessary, press the SETUP 1 Softkey to select the System Setup 1 Page.
4) Press the FMS Knob momentarily to activate the flashing cursor.
5) Turn the large FMS Knob to highlight the distance field in the Arrival Alert Box.
6) Use the FMS Knob to enter a trigger distance and press the ENT Key.
7) Press the FMS Knob to deactivate the cursor.
a a
UDiO leRts
The Audio Alert Box on the System Setup 1 Page allows the audio alert voice to be set to male or female.
To change the audio alert voice:
1) While on the System Setup 1 Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the voice in the Audio Alert Box.
3) Turn the small FMS Knob to display and highlight the desired voice and press the ENT Key.
F D
light iRectOR
Two formats are available for the display of the flight director. Single Cue or X-Pointer may be selected.
To change the flight director format:
1) While on the System Setup 1 Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the Format Active field in the Flight Director Box.
3) Turn the small FMS Knob to display and highlight the desired flight director format and press the ENT Key.
mFD D
ata
The MFD Data Bar Fields Box on the System Setup 1 Page displays the current configuration of the MFD
Navigation Status Box. By default, the Navigation Status Bar is set to display ground speed (GS), distance
to next waypoint (DIS), estimated time en route (ETE), and en route safe altitude (ESA).
To change the information shown in an MFD Navigation Status Bar field:
1) While on the System Setup 1 Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the desired field number in the MFD Data Bar Fields Box.
3) Turn the small FMS Knob to display and scroll through the data options list and press the ENT Key when the
desired data selection is highlighted.
190-01255-00 Rev. A
B F
aR ielDs
Garmin G1000H ™ Pilot's Guide for the Bell 407GX
SYSTEM OVERVIEW
35