Garmin G1000H Pilot's Manual page 506

APPENDIX A
MISCELLANEOUS MESSAGE ADVISORIES (CONT.)
Message
WPT ARRIVAL – Arriving at
waypoint -[xxxx]
STEEP TURN – Steep turn ahead.
INSIDE ARSPC – Inside airspace.
ARSPC AHEAD – Airspace ahead
less than 10 minutes.
ARSPC NEAR – Airspace near and
ahead.
ARSPC NEAR – Airspace near – less
than 2 nm.
APR INACTV – Approach is not
active.
SLCT FREQ – Select appropriate
frequency for approach.
SLCT NAV – Select NAV on CDI for
approach.
PTK FAIL – Parallel track unavailable:
bad geometry.
PTK FAIL – Parallel track unavailable:
invalid leg type.
PTK FAIL – Parallel track unavailable:
past IAF.
UNABLE V WPT – Can't reach
current vertical waypoint.
VNV – Unavailable. Unsupported
leg type in flight plan.
VNV – Unavailable. Excessive track
angle error.
VNV – Unavailable. Excessive
crosstrack error.
VNV – Unavailable. Parallel course
selected.
NO WGS84 WPT – Non WGS 84
waypoint for navigation -[xxxx]
TRAFFIC FAIL – Traffic device has
failed.
FAILED PATH – A data path has
failed.
494
Comments
Arriving at waypoint [xxxx], where [xxxx] is the waypoint name.
A steep turn is 15 seconds ahead. Prepare to turn.
The aircraft is inside the airspace.
Special use airspace is ahead of aircraft. The aircraft will penetrate the airspace within
10 minutes.
Special use airspace is near and ahead of the aircraft position.
Special use airspace is within 2 nm of the aircraft position.
The system notifies the pilot that the loaded approach is not active. Activate approach
when required.
The system notifies the pilot to load the approach frequency for the appropriate NAV
receiver. Select the correct frequency for the approach.
The system notifies the pilot to set the CDI to the correct NAV receiver. Set the CDI to
the correct NAV receiver.
Bad parallel track geometry.
Invalid leg type for parallel offset.
IAF waypoint for parallel offset has been passed.
The current vertical waypoint can not be reached within the maximum flight path angle and
vertical speed constraints. The system automatically transitions to the next vertical waypoint.
The lateral flight plan contains a procedure turn, vector, or other unsupported leg
type prior to the active vertical waypoint. This prevents vertical guidance to the active
vertical waypoint.
The current track angle error exceeds the limit, causing the vertical deviation to go
invalid.
The current crosstrack exceeds the limit, causing vertical deviation to go invalid.
A parallel course has been selected, causing the vertical deviation to go invalid.
The position of the selected waypoint [xxxx] is not calculated based on the WGS84
map reference datum and may be positioned in error as displayed. Do not use GPS to
navigate to the selected non-WGS84 waypoint.
The system is no longer receiving data from the traffic system. The traffic device should
be serviced.
A data path connected to the GDU, GSD 41, or the GIA 63/W has failed.
Garmin G1000H ™ Pilot's Guide for the Bell 407GX
190-01255-00 Rev. A