G1000H System Annunciations - Garmin G1000H Pilot's Manual

G1000H SYSTEM ANNUNCIATIONS

When a new message is issued, the MSG Softkey will flash to alert the flight crew of a new message. It
will continue to flash until acknowledged by pressing the softkey. Active messages are displayed in white
text. Messages that have become inactive will change to gray text. The MSG Softkey will flash if the state of
a displayed message changes or a new message is displayed. The inactive messages can be removed from the
Message Window by pressing the flashing MSG Softkey.
The G1000H System Messages conveys messages to the flight crew regarding problems with the G1000H
system. Typically, a large red "X" appears in a window when a related LRU fails or detects invalid data.
When an LRU or an LRU function fails, a large red "X" is typically displayed on windows associated with the
failed data. The following section describes various system annunciations. Refer to the RFM for additional
information regarding pilot responses to these annunciations.
Upon power-up of the G1000H system, certain windows remain invalid as G1000H equipment begins
NOTE:
to initialize. All windows should be operational within one minute of power-up. Should any window
continue to remain flagged, the G1000H system should be serviced by a Garmin-authorized repair facility.
190-01255-00 Rev. A
System
Annunciation
Red 'X'
Figure A-1 G1000H System Messages
Garmin G1000H ™ Pilot's Guide for the Bell 407GX
Messages Window
Message Softkey
Annunciation
APPENDIX A
481