Registering Your Station Id - Kyocera KM-2030 Instruction Handbook Manual

Section 1 Basic Use of this Fax
Entering your station name
4
Enter the desired name for your station.
(Refer to "Entering Characters", page 1-30.)
* Your station name can be up to 32 characters in length.
* The station name registered here will be shown in the
message display of the other party's fax, as well as on the
Reception Report that they print out. (This function is only
guaranteed to work when the other party's fax is one of our
models.)
* If you want to clear the currently displayed name from the
message display, simply press the Stop/Clear key.
(Inch)
S-Pjt
Enter Own Name
S-Pjt
Enter own name
Press the Enter key.
5
Registration of your station name is complete.
* To return to the initial mode settings, press the Reset key.
Program Fax Parameter:
End
v :
Own Name
1-12
(Metric)
(Inch)
(Lower case)
(Metric)
(Small letter mode)
:S-Pjt

3 Registering your station ID

* Use the following procedure as well when you want to
change information that is already registered.
* If you want to cancel the procedure part way through,
press the Reset key. The operation panel will return to the
initial mode settings.
Perform steps 1 - 4 of "1 Registering your fax number",
1
page 1-10.
Program Fax Parameter:
End
v :
Own Name
Use the cursor up or the cursor down key to select "Own ID".
2
(Inch)
Program Fax Parameter:
v :
Own Name
Own ID
:
(Metric)
:
:0000