Changing A Department Name - Kyocera KM-2030 Instruction Handbook Manual

3. Press the Enter key.
Program Fax Parameter:
End
v :
Own Name
4. Use the cursor up or the cursor down key to select "Access Code".
Program Fax Parameter:
Remote Test ID:0000
Date & Time
Access Code
Program fax parameter:
Remote test ID:0000
Date and time :12:00
Access code
5. Press the Enter key.
Enter Your Password
6. Use the keypad to enter the currently registered management
password (4 digits).
* If you enter the wrong password, an error message will be
displayed. In this case, press the Enter key and enter the correct
password.
Enter Your Password
7. Use the cursor up or the cursor down key to select an
unregistered access code no. from among #01 - #50.
Access Code:
#01:
#02:
#03:
8. Press the Enter key.
#03:0000
Enter Access Code
9. Use the keypad to enter the desired access code.
* Each access code is a 4-digit number that can include any
combination of the numerals 0 - 9.
#03:3363
Enter Access Code
(Inch)
:12:00
P P
(Metric)
P P
Section 4 Other Features of this Fax
10. Press the Enter key.
#03:
Department Name
#03:
ID-code name
11. Enter the desired department name.
(Refer to "Entering characters", page 1-30.)
* The department name can be up to 32 characters in length.
* Press the Stop/Clear key to clear the currently displayed name
from the message display.
#03:SKL-G
Department Name
#03:SKL-G
ID-code name
12. Press the Enter key.
Registration of that access code is complete.
Access Code:
#01:
#02:
#03:3363:SKL-G
> If you want to continue registering other access codes, repeat
steps 7 - 12.
> If you are finished registering access codes, press the Reset
key. The operation panel will return to the initial mode settings.

(6) Changing a Department Name

Perform the following procedure when you want to change a
registered department name.
* You will need to enter the registered management password when
you want to change a department name. (Refer to "Registering the
Management Password", page 6-17.)
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
Set original
1. Perform steps 1 - 6 of "(5) Registering Access Codes", page 4-50.
2. Use the cursor up or the cursor down key to select the access
code that corresponds to the department name to be changed.
Access Code:
#01:
#02:
#03:3363:SKL-G
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
08-JUL-2001 12:00
(Metric)
4-51