Kyocera KM-2030 Instruction Handbook Manual page 78

Section 3 Troubleshooting
Message
"Misfeed in feeder.
Remove original(s)."
"Memory Full"
"Call for Service"
"Time for maintenance."
"Communication Error."
"Continue TX"
["Continue transmission"]
"Original is too long."
["Original sheet is too long"]
3-4
A document has jammed in the DF. Refer to the included Instruction Handbook for
your DF or copier and remove the jammed document.
Then, reset all of the documents in the DF. The fax will recount the number of
documents that were already scanned and will start the scanning operation once again
from the document that jammed.
The memory has reached its capacity while scanning in documents. Press the Enter
key and perform the appropriate procedure according to the contents of the message
display.
If you do not press the Enter key within a certain amount of time, the Auto Clear
function will engage and all corresponding data will be erased from memory.
Maintenance by qualified service personnel is required. Contact your service
representative, an authorized service center or the place of purchase.
If "C" and a 3-digit number are displayed as well, inform the service personnel of the
displayed number.
Maintenance by qualified service personnel is required. Contact your service
representative, an authorized service center or the place of purchase.
An error has occurred during a fax transmission or fax reception.
Check the error code – that indicates the origin of the error – on the corresponding
Transmission Report (or Reception Report) that is printed out after the error.
This message will appear in response to pressing the Stop/Clear key while the
Alternate Display key is held down during a communication to multiple destinations,
such as Broadcast Transmission or Polling Reception.
• Use the cursor up or the cursor down key to select "Yes" if you want to continue the
current operation. However, the individual communication in progress at the time the
Stop/Clear key was pressed will be canceled.
• Use the cursor up or the cursor down key to select "No" if you want to cancel the
communication to all remaining destinations.
You attempted to use the DF to transmit a document that was over 63" [1600 mm] in
length. Press the Enter key to eject the documents remaining in the DF. The operation
panel will return to the initial mode settings.
Procedure Page
___
2-18
4-13
___
___
8-9
___
1-22