Selecting The Reception Mode - Kyocera KM-2030 Instruction Handbook Manual

Section 6 Various Settings and Registration in this Fax

Selecting the Reception Mode

This fax has 5 reception modes [4 modes in the metric version].
However, except for Manual Fax Reception and TAD Reception, it is
necessary to select the desired mode in advance in order to use any
of the other reception modes (Automatic Fax Reception, Auto
FAX/TEL Switching and D.R.D. Reception [D.R.D. Reception is
available in the inch version only]).
* Refer to "Manual Fax Reception", page 2-20, and "TAD Reception",
page 4-3, for information on selecting these two modes.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
Set Document
Set original
1. Raise the cover plate and press the Configure key.
(Inch)
Set Fax:
End
Line Type
TTI
Set fax:
End
TTI
Print report
2. Use the cursor up or the cursor down key to select "Receive Mode".
Set Fax:
Scan from ADF :Std size
TX Mode/Default:Memory Tr
Receive Mode
Set fax:
DF scanning
TX mode/Default:Memory Tr
Reception mode:Fax recept
3. Press the Enter key.
Receive Mode:
*Fax Reception
Auto Fax/Tel SW
D.R.D.
Reception mode:
*Fax reception
Auto Fax/Tel switching
6-10
JUL-08-2001 12:00
(Inch)
08-JUL-2001 12:00
(Metric)
(Metric)
(Inch)
:Tone Dial
:Outside P.
(Metric)
:Outside p.
P P
(Inch)
:Fax Recept
:Std. orig.
(Metric)
(Inch)
P P
(Metric)
4. Use the cursor up or the cursor down key to select the desired
reception mode.
* The asterisk ( * ) in the message display indicates the current
setting.
> Metric version: Proceed to step 7.
> Inch version and "D.R.D." was selected: Proceed to step 5.
> Inch version and any reception mode other than D.R.D. was
selected: Proceed to step 7.
5. Press the Enter key.
D.R.D. Ring Pattern:
Normal Ring
Double Ring
Short-Short-Long
6. Use the cursor up or the cursor down key to select the desired ring
pattern.
* Select among the 4 available patterns: "Normal Ring",
"Double Ring", "Short-Short-Long" and "Short-Long-Short"
7. Press the Enter key. The setting for the reception mode is complete.
* If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.