Turning Tti Transmission On/Off - Kyocera KM-2030 Instruction Handbook Manual

(2) Turning TTI Transmission ON/OFF

The TTI (Transmit Terminal Identifier) refers to information – such as
the time of the transmission, the number of pages, your station name
and fax number, etc. – that is automatically sent to the receiving
party's fax and printed out on the received documents. With this fax,
the user can select here whether or not that TTI information will be
sent to the receiving party's fax, and – if it is – whether it will be
printed inside or outside the border of the transmitted page.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
Checking the initial mode display
1
Check the message display to make sure that the operation
panel is in the initial mode for fax operation.
(Refer to "(2) Initial Mode", page 1-14.)
* If the fax is not in the Fax Operation mode, press the
COPY/FAX switching key to light the FAX indicator.
Set Document
Set original
Raising the cover plate
2
Raise the cover plate that is located over the one-touch keys
on the right side of the operation panel.
Entering the "Set Fax" mode
3
Press the Configure key.
The "Set Fax" menu will appear in the message display.
(Inch)
Set Fax:
End
Line Type
TTI
Set fax:
End
TTI
Print report
JUL-07-2001 10:00
(Inch)
07-JUL-2001 10:00
(Metric)
(Metric)
(Inch)
:Tone Dial
:Outside P.
(Metric)
:Outside p.
P P
Section 1 Basic Use of this Fax
Use the cursor up or the cursor down key to select "TTI".
4
(Inch)
Set Fax:
End
Line Type
TTI
Set fax:
End
TTI
Print report
Press the Enter key.
5
* The asterisk ( * ) in the message display indicates the current
setting.
(Inch)
TTI:
*Outside Page
Inside Page
Do not Print
(Metric)
(Inch)
:Tone Dial
:Outside P.
(Metric)
:Outside p.
P P
(Metric)
1-7