Preparations; Setting The Type Of Phone Line - Kyocera KM-2030 Instruction Handbook Manual

Section 1 Basic Use of this Fax

Preparations

When using the fax functions of this machine for the first time after
purchase, perform the procedures as explained in "(1) Setting the
Type of Phone Line" through "(4) Registering Self-Station Information".
(1) Setting the Type of Phone Line (Inch
version only)
Set the type of phone line here to correspond to the type of
telephone service that you are using. BE SURE the type of phone
line you select here is correct because, if the setting is incorrect,
dialing – and therefore fax communication – will be impossible.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
Switching to the Fax Operation mode
1
Press the COPY/FAX switching key to light the FAX indicator.
* When the FAX indicator is lit, the machine is in the Fax
Operation mode.
Checking the initial mode display
2
Check the message display to make sure that the operation
panel is in the initial mode for fax operation.
(Refer to "(2) Initial Mode", page 1-14.)
Set Document
Raising the cover plate
3
Raise the cover plate that is located over the one-touch keys
on the right side of the operation panel.
1-6
JUL-07-2001 10:00
Entering the "Set Fax" mode
4
Press the Configure key.
The "Set Fax" menu will appear in the message display.
Set Fax:
End
Line Type
TTI
Make sure that "Line Type" is selected in the message display
5
and press the Enter key.
* The asterisk ( * ) in the message display indicates the current
setting.
Line Type:
*Tone(DTMF) Line
Pulse(10PPS) Line
Selecting the type of phone line
6
Use the cursor up or the cursor down key to select the type of
phone line that you are using.
* Select between "Tone(DTMF) Line" and "Pulse(10PPS) Line".
Line Type:
*Tone(DTMF) Line
Pulse(10PPS) Line
Press the Enter key.
7
The setting for the type of phone line is complete.
* To return to the initial mode settings, use the cursor up or the
cursor down key to select "End". Then press the Enter key.
:Tone Dial
:Outside P.