Kyocera KM-2030 Instruction Handbook Manual page 33

Initiating the fax transmission
7
Press the Start key.
* The transmission operation will begin automatically.
(Inch)
v :13579
01Page
E F
Storing
v :13579
01Page
E F
Now scanning
> Checking the status of the transmission
Raise the cover plate and hold down the Alternate Display
key. The status of the transmission currently in progress will
be shown in the message display during the time that this key
is held down.
Once you release the Alternate Display key, the message
display will return to its previous state.
(Inch)
v :13579
01Page
Communicating
v :13579
01Page
Communicating
> Stopping the transmission in progress
To stop the transmission in progress, raise the cover plate,
hold down the Alternate Display key and press the Stop/Clear
key. The transmission will be canceled.
(Inch)
(Metric)
Doc # :056
(Inch)
1
Document:8 / x11
2
Doc. nr :056
(Metric)
Document:A4
(Metric)
Doc # :056
(Inch)
Doc. nr :056
(Metric)
(Metric)
Section 1 Basic Use of this Fax
<When the documents are set on the platen...>
Whenever you set the documents that you want to transmit on the
platen, close the DF in order to allow the machine to detect the size
of those documents. If you are transmitting information from books
or other types of documents that will not allow you to close the DF,
press the Original key to manually select the correct size of the
documents to be transmitted.
* In addition, any time you set documents on the platen a menu like
that shown below will appear in the message display once you
press the Start key. In this case, perform the following procedure.
Continue Scanning:
Yes
No
1 Use the cursor up or the cursor down key to select whether or
not you want to scan more pages into memory.
If you DO want to scan more pages, select "Yes".
If there are no further pages to be scanned, select "No".
* If you selected "No", proceed to step 3.
Continue Scanning:
Yes
No
2 Set the next document.
* It is also possible to set the next document(s) in the DF.
3 Press the Enter key.
If you selected "Yes" in step 1, scanning of the next document
will begin. If there are still further documents to be scanned,
repeat steps 1 to 3 until all documents are scanned in. Once
you select "No" in step 1, the fax will automatically begin
transmission of all of the documents scanned into memory.
1-25