Kyocera KM-2030 Instruction Handbook Manual page 170

Section 8 Reference Information
CODE
A communication error occurred during transmission at high transmission speed. The destination party's fax may not have
the corresponding high speed reception capabilities. If the destination party's fax number was dialed using an abbreviated
U01721
number or one-touch key, change the transmission speed registered for that number to a lower setting and perform
transmission procedures again.
U01800 - A communication error occurred during reception at high transmission speed. Perform reception procedures again after
U01820 having the transmitting party lower the transmission speed.
A communication error occurred during reception at high transmission speed. Your unit may not have the corresponding
U01821 high speed reception capabilities. Perform reception procedures again after having the transmitting party lower the
transmission speed.
Polling reception was attempted, but was unsuccessful because no documents had been placed in advance in the
U03000
transmitting party's fax. Check with the transmitting party.
The transmitting party's fax is one of our models and an F-Code Based Bulletin Board Reception was attempted in order to
U03200 receive documents from that party's F-Code Box, but was unsuccessful because there were no documents stored in the
corresponding F-Code Box.
An error has occured due to one of the following reasons. Check with the other party.
1 A Polling Reception was attempted in order to receive documents from the other party's fax, but was unsuccessful
because Password Check Communication was turned ON in the other party's fax and the necessary password did not
U03300 match.
2 The transmitting party's fax is one of our models and an F-Code Based Bulletin Board Reception was attempted in order
to receive documents from that party's F-Code Box, but was unsuccessful because Password Check Communication
was turned ON in the other party's fax and the necessary password did not match.
Polling reception was attempted, but was unsuccessful because the password input in the transmitting party's fax and the
U03400
self-station ID of the receiving party did not match. Check with the other party.
The transmitting party's fax is one of our models and an F-Code Based Bulletin Board Reception was attempted in order to
U03500 receive documents from that party's F-Code Box, but was unsuccessful because the F-Code Box number that you entered
was not registered in the other party's fax.
The transmitting party's fax is one of our models and an F-Code Based Bulletin Board Reception was attempted in order to
U03600 receive documents from that party's F-Code Box, but was unsuccessful because the F-Code password that you entered did
not match the one registered in the transmitting party's fax.
An F-Code Based Bulletin Board Reception was attempted in order to receive documents from the other party, but was
U03700 unsuccessful because the other party's fax does not have F-Code Based Bulletin Board Transmission capabilities or
because there were no documents stored in the corresponding box.
The destination fax is one of our models and an F-Code Based Confidential Transmission was attempted in order to
U04000 transmit documents to that party's F-Code Box, but was unsuccessful because the F-Code Box number that you entered
was not registered in the destination party's fax.
A transmission to a destination party's box (ex. F-Code Box) was attempted, but was unsuccessful because the destination
U04100
party's fax does not have F-Code Based Confidential Reception capabilities.
Encryption transmission was attempted, but was unsuccessful because the specified destination Confidential Box was not
U04200
designated for encryption reception or was not registered in the other party's fax.
Encryption transmission was attempted, but was unsuccessful because the other party's fax does not possess Encryption
U04300
Communication capabilities.
U04400 Encryption Transmission was attempted, but was unsuccessful because the Encryption Keys did not match.
Encryption Transmission was attempted, but the other party was not dialed because the designated Encryption Key is not
U04401
registered in your unit.
U04500 Encryption Reception was attempted, but was unsuccessful because the Encryption Keys did not match.
8-10
CAUSE AND/OR PROCEDURE FOR CORRECTION