HYOSUNG COMET 125 Service Manual page 65

REASSEMBLY
Apply a small quantity of THREAD LOCK 1324 to
the starter clutch bolts and tighten them to the spec-
ified torque while holding the rotor with the rotor
holder.
Thread Lock 1324
Rotor holder : 09930-44510
Starter clutch bolt
: 15~20 N m(1.5~2.0 kg m)
STARTER DRIVEN GEAR
STARTER DRIVEN GEAR BUSHING
Install the starter driven gear bushing
onto the crankshaft and turn the starter driven
gear by hand. Inspect the starter driven gear bushing
for smooth rotation and any abnormal noise. If the
bushing does not turn smoothly or there is any abnor-
mal noise, replace it.
DISASSEMBLY
Remove the bushing using the special tool.
Bearing remover(20~35 mm)
CLUTCH COVER
OIL FILTER REPLACEMENT(Refer to page 2-10)
DISASSEMBLY
Remove the circlip and right crankshaft oil seal.
Oil seal remover : 09913-50121
and gear
: 09923-74510
ENGINE 3-28