HYOSUNG COMET 125 Service Manual page 76

3-39 ENGINE
GEARSHIFT SHAFT
Install the gear shifting shaft. Match the center teeth of
the gear on the shifting shaft with the center teeth on the
shifting driven gear as shown.
CAUTION
After the cam driven gear, cam guide, gear shift
shaft and neutral cam stopper have been fitted,
confirm that gear change is normal while turning,
the countshaft and driveshaft. If gear change is
not obtained, it means that assembly of gears or
installation of gear shifting fork is incorrect. In
this case, disassemble and trace the mistake.
OIL PUMP
Before installing the oil pump, apply the engine oil to
the contact face of case, outer rotor, inner rotor and
shaft.
Apply a small quantity THREAD LOCK 1324 to the
oil pump securing screws.
THREAD LOCK 1324
Tighten the oil pump securing screws.
Install the oil pump pin.
Put in the oil pump driven gear, and install the circlip.