HYOSUNG COMET 125 Service Manual page 80

3-43 ENGINE
Install the clutch pressure plate
and clutch spring mounting bolts.
Hold the primary drive gear nut and tighten the clutch
spring mounting bolts in a crisscross pattern.
NOTE
Make sure that the clutch pressure plate is
installed correctly.
CLUTCH COVER
Install the two dowel pins and new gasket
Apply engine oil to each gears, bearings and clutch
plates.
Install the clutch cover, and tighten the clutch cover
bolts securely.
Install the clutch release arm as following:
Turn the clutch release shaft toward(This time,
mark on the shaft align outside contact line the
stopper screw) the right.
Install that the cable connecting center line of the
clutch release arm align matching mark rightside of
the case as shown in the right figure.
clutch springs
Stopper screw
Clutch release
arm bolt
Clutch release
arm
Release camshaft
notch mark
Crankcase
matching mark