HYOSUNG COMET 125 Service Manual page 133

6-9 CHASSIS
Apply SILICONE GREASE to the brake caliper hold-
er.
SILICONE GREASE
Install the brake pads. (Refer to page 2-14)
Tighten the caliper mounting bolts
With the hose end seated to the stopper, tighten the
union bolt
Front brake caliper mounting bolts
Front brake hose union bolts
Fill the system with brake fluid and bleed air. (Refer to
page 2-16)
Inspection after reassembly : Refer to page 2-14
BRAKE DISC INSPECTION
Check the brake disc for damage or cracks. Measure the
thickness using the micrometer.
Replace the brake disc if the thickness is less than the
service limit or if damage is found.
Micrometer (0 25 mm) : 09900 - 20201
Brake disc thickness
Measure the runout using the dial gauge.
Replace the brake disc if the runout exceeds the service
limit.
Dial gauge : 09900 - 20606
Magnetic stand : 09900 - 20701
Brake disc runout
If either measurement exceeds the service limit,
replace the brake disc. (Refer to page 6-3)
.
:18~28 N m (1.8~2.8 kg m)
:20~25 N m (2.0~2.5 kg m)
Service limit
3.0 mm (0.12 in)
Service limit
0.3 mm (0.012 in)