Piston - HYOSUNG COMET 125 Service Manual

Remove the two cylinder base nuts and cylinder.
CAUTION
If tapping with the plastic hammer is necessary,
pay attention to break the fins.
Remove the rear cylinder head and cylinder with the
same manner of the front cylinder head and cylinder
removal.
PISTION
Place a clean rag over the cylinder base to prevent
piston pin circlips from dropping into crankcase.
Remove the piston pin circlips with long-nose pliers.
Remove the piston pin by using the special tool.
Piston pin puller : 09910-34510
NOTE
Make an identification on each piston head so
that confirmed the cylinder.
Rear Cylinder
ENGINE 3-12
Front Cylinder