HYOSUNG COMET 125 Service Manual page 153

6-29 CHASSIS
INSPECTION
Inspect and check the removed parts for the following
abnormalities.
Handlebar distortion.
Handlebar clamp wear.
Abnormality operation of bearing.
Worn or damaged races.
Distortion of steering stem.
REASSEMBLY
Reassemble and remount the steering stem in the
reverse order of disassembly and removal, and also
carry out the following steps :
Apply SUPER GREASE A to the upper bearing
and lower bearing
SUPER GREASE A
Tighten the steering stem nut
Clamp wrench : 09940-10122
Steering stem nut : 80~100 N m (8.0~10.0kg m)
Turn the steering stem right and left, lock-to-lock, five or
six times.
Tighten the steering stem head nut to the specified
torque.
Steering stem head nult : 80~100 N m
CAUTION
After performing the adjustment and installing
the steering stem upper bracket, rock the front
wheel assembly forward and backward to ensure
that there is no play and that the procedure was
accomplished correctly. If play is noticeable, re-
adjust the steering stem nut.
Set the handlebars to match its punched mark to the
mating face of the holder.
Secure the each handlebar clamp bolts in such a way
that the clearances ahead of and behind the handle-
bars should be equalized.
Handlebar clamp bolts
.
with the special tool.
(8.0~10.0 kg m)
: 18~28 N m (1.8~2.8 kg m)