HYOSUNG COMET 125 Service Manual page 64

3-27 ENGINE
Crankshaft runout
Magnetic stand : 09900-20701
Dial gauge : 09900-20606
V-block : 09900-21304
CRANKSHAFT REASSEBLY
Measure the width between the webs referring to the fi-
gure below when rebuilding the crankshaft.
Width between webs
MAGNETO COVER
MAGNETO INSPECTION(Refer to page 5-4)
DISASSEMBLY
Remove the stator
STARTER CLUTCH
Install the starter driven gear onto the starter clutch and
turn the starter driven gear by hand(the gear turns in
only one direction). The starter driven gear should
turn smoothly. If excessive resistance is felt while turn-
ing the starter driven gear, inspect the starter
clutch. Also, inspect the surface of the starter driven
gear which contacts the starter clutch, for wear or dam-
age. If any wear or damage is found, replace the
defective parts.
DISASSEMBLY
Hold the magneto rotor with the rotor holder and
remove the starter clutch bolts.
Rotor holder : 09930-44510
Service limit
0.05 mm (0.002 in)
Standard
72 0.1 mm
(2.84 0.004 in)
(2.84 0.004 in)