Caution: Do not power down the system during the BIOS update process!
Note: You may encounter a CMOS Checksum error or other problem after reboot. If this
happens, shut down the compute module and boot it again. CMOS checksum errors
require that you enter Setup, check your settings, save your settings, and exit Setup.
Clearing the Password
If the user or administrator password(s) is lost or forgotten, moving the password clear
jumper into the "clear" position clears both passwords. You must restore the password
clear jumper to its original position before you can set a new password(s). The password
clear jumper is located on jumper block J9A3.
1. Power down the compute module.
2. Remove the compute module from the Intel
3. Remove the compute module cover. For instructions, refer to
Top Cover" on page -14
4. Move the jumper (J9A3) from the default operating position, covering pins 1 and 2, to
the password clear position, covering pins 2 and 3.
®
Intel
Compute Module MFS5520VI User Guide
®
Modular Server System.
Section , "Removing the
89