Table of Contents
Advertisement
GS108T and GS110TP Smart Switch Software Administration Manual
Figure 2-17
The SNMPv3 Access Mode is a read-only field that shows the access privileges for the user account.
The admin account always has Read/Write access, and all other accounts have Read Only access.
To configure SNMPv3 settings for the user account:
1. In the Authentication Protocol field, specify the SNMPv3 Authentication Protocol setting for
the selected user account. The valid Authentication Protocols are None, MD5, or SHA. If you
select:
•
None: The user will be unable to access the SNMP data from an SNMP browser.
•
MD5 or SHA: The user login password will be used as SNMPv3 authentication password,
and you must therefore specify a password. The password must be eight characters in
length.
2. In the Encryption Protocol field, choose whether to encrypt SNMPv3 packets transmitted by
the switch.
•
None. Do not encrypt the contents of SNMPv3 packets transmitted from the switch.
•
DES. Encrypt SNMPv3 packets using the DES encryption protocol.
3. If you selected DES in the Encryption Protocol field, enter the SNMPv3 Encryption Key here.
Otherwise, this field is ignored. Valid keys are 0 to 15 characters long.
4. Click Apply to send the updated configuration to the switch. Configuration changes take
effect immediately.
5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
2-30
v1.0, April 2010
Configuring System Information
Hide quick links:
Advertisement
Table of Contents
