NETGEAR GS108T-200NAS Software Administration Manual page 127

• Host Timeout. Specify the amount of time you want the switch to wait for a report for a
particular group on a particular interface before it deletes that interface from the group.
Enter a value between 2 and 3600 seconds. The default is 260 seconds.
• Max Response Time. Specify the amount of time you want the switch to wait after
sending a query on an interface because it did not receive a report for a particular group on
that interface. Enter a value greater or equal to 1 and less than the Host Timeout, in
seconds. The default is 10 seconds.
• MRouter Timeout. Specify the amount of time you want the switch to wait to receive a
query on an interface before removing it from the list of interfaces with multicast routers
attached. Enter a value between 0 and 3600 seconds. The default is 0 seconds. A value of
zero indicates an infinite timeout; no expiration.
• Fast Leave Admin Mode. Select the Fast Leave mode for a particular interface from the
menu. The default is Disable.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
7. If you make any configuration changes, click Apply to apply the new settings to the switch.
Configuration changes take effect immediately.
IGMP Snooping Table
Use the IGMP Snooping Table page to view all of the entries in the Multicast Forwarding
Database that were created for IGMP snooping.
To access the IGMP Snooping Table page, click Switching Multicast  IGMP Snooping 
IGMP Snooping Table.
Configuring Switching Information
GS108T and GS110TP Smart Switch Software Administration Manual
v1.0, April 2010
3-43