NETGEAR GS108T-200NAS Software Administration Manual page 44

GS108T and GS110TP Smart Switch Software Administration Manual
To configure the time through SNTP:
1. From the Clock Source field, select SNTP.
When the Clock Source is set to SNTP, the Date and Time fields are grayed out (disabled).
The switch gets the date and time from the network.
2. Use the menu to select the Coordinated Universal Time (UTC) time zone in which the switch
is located, expressed as the number of hours. The options in the Time Zone menu specify the
time difference from UTC time zone.
3. Click Apply to send the updated configuration to the switch. Configuration changes take
effect immediately.
4. Use the SNTP Server Configuration page to configure the SNTP server settings, as
described in "SNTP Server Configuration" on page
5. Click Refresh to refresh the page with the most current data from the switch.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
The SNTP Global Status table on the Time Configuration page displays information about the
system's SNTP client. The following table describes the SNTP Global Status fields.
Table 2-2. SNTP Global Status Fields
Field
Version
Supported Mode
Last Update Time
Last Attempt Time
2-8
Description
Specifies the SNTP Version the client supports.
Specifies the SNTP modes the client supports. Multiple modes may be
supported by a client.
Specifies the local date and time (UTC) the SNTP client last updated the
system clock.
Specifies the local date and time (UTC) of the last SNTP request or receipt
of an unsolicited message.
v1.0, April 2010
2-9.
Configuring System Information