NETGEAR GS108T-200NAS Software Administration Manual page 49

To configure the Auto-DoS feature:
1. Select a radio button to enable or disable Auto-DoS:
• Disable. Auto-DoS is disabled (default).
• Enable. Auto-DoS is enabled.
2. Click Apply to send the updated configuration to the switch. Configuration changes occur
immediately.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
DoS Configuration
The DoS Configuration page lets you to select which types of DoS attacks for the switch to
monitor and block.
To access the DoS Configuration page, click System  Management  Denial of Service > DoS
Configuration.
Figure 2-6
Configuring System Information
GS108T and GS110TP Smart Switch Software Administration Manual
v1.0, April 2010
2-13