NETGEAR GS108T-200NAS Software Administration Manual page 124

GS108T and GS110TP Smart Switch Software Administration Manual
IGMP Snooping Configuration
Use the IGMP Snooping Configuration page to configure the parameters for IGMP snooping,
which is used to build forwarding lists for multicast traffic.
To access the IGMP Snooping Configuration page, click Switching Multicast  IGMP
Snooping  IGMP Snooping Configuration.
Figure 3-27
To configure IGMP Snooping:
1. Enable or disable IGMP Snooping on the switch.
• Enable. The switch snoops all IGMP packets it receives to determine which segments
should receive packets directed to the group address.
• Disable. The switch does not snoop IGMP packets.
2. Click Apply to send the updated configuration to the switch. Configuration changes take
effect immediately.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch
3-40
v1.0, April 2010
Configuring Switching Information