NETGEAR GS108T-200NAS Software Administration Manual page 52

GS108T and GS110TP Smart Switch Software Administration Manual
3. To specify the DNS server to which the switch sends DNS queries, enter an IP address in
standard IPv4 dot notation in the DNS Server Address and click Add. The server appears in
the list below. You can specify up to eight DNS servers. The precedence is set in the order
created.
4. To remove a DNS server from the list, select the check box next to the server you want to
remove and click Delete. If no DNS server is specified, the check box is global and will delete
all the DNS servers listed.
5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
6. Click Apply to send the updated configuration to the switch. Configuration changes take
effect immediately.
Host Configuration
Use this page to manually map host names to IP addresses or to view dynamic DNS mappings.
To access this page, click System  Management  DNS  Host Configuration.
Figure 2-8
To add a static entry to the local DNS table:
1. Specify the static host name to add. Enter up to 158 characters.
2-16
v1.0, April 2010
Configuring System Information