NETGEAR GS108T-200NAS Software Administration Manual page 101

Figure 3-12
To configure Voice VLAN:
1. From the Voice VLAN Status field, enable or disable Voice VLAN on the switch. If the
switch does not handle traffic from IP phones, the status should be disabled.
2. From the Voice VLAN ID field, select the VLAN to use for voice traffic on the switch. The
VLAN must already exist on the switch. For information about how to create VLANs, see
"VLAN Configuration" on page
3. From the Class of Service field, set the CoS tag value to be reassigned for packets received on
the Voice VLAN when Remark CoS is enabled.
4. From the Remark CoS field, select Enable or Disable to reassign the CoS tag value to packets
received on the Voice VLAN.
5. From the Voice VLAN Aging Time field, specify the amount of time after the last IP phone's
OUI is aged out for a specific port. The port will age out after the bridge and voice aging time.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
7. If you make any changes to this page, click Apply to send the updated configuration to the
switch.
Configuring Switching Information
GS108T and GS110TP Smart Switch Software Administration Manual
3-11.
v1.0, April 2010
3-17