Setting Up Security; Setting Security Access; Setting Ilo 2 Mp Lan From Efi - HP Integrity BL870c Operation Manual

a. Access the MP Main Menu.
b. Enter CM at the MP> prompt.
c. Enter UC at the MP:CM> prompt and follow the prompts to modify default passwords.
3. To set up user accounts, follow these steps:
a. Access the MP Main Menu.
b. Enter CM at the MP> prompt.
c. Enter UC at the MP:CM> prompt and follow the prompts to modify user accounts.

Setting Up Security

For greater security and reliability, HP recommends that iLO 2 management traffic be on a
separate dedicated management network and that only administrators be granted access to that
network. This not only improves performance by reducing traffic load across the main network,
it also acts as the first line of defense against security attacks. A separate network enables you
to physically control which workstations are connected to the network.

Setting Security Access

Determine the security access required and what user accounts and privileges are needed. iLO
2 provides options to control user access. Select one of the following options to prevent
unauthorized access to iLO 2:
• Change the default user name and password. See
Passwords" (page
CAUTION:
anyone can access iLO 2 until you change the default user name and password.
HP strongly recommends you assign user groups and rights before proceeding.
• Create local accounts. You can store up to 19 user names and passwords to manage iLO 2
access. This is ideal for small environments such as labs and small-to-medium sized
businesses.
• Use corporate directory services to manage iLO 2 user access. This is ideal for environments
with a large number of frequently changing users. If you plan to use directory services, HP
recommends leaving at least one local account enabled as an alternate method of access.
For more information on how to create local accounts and use directory services, see
"Installing and Configuring Directory Services " (page

Setting iLO 2 MP LAN From EFI

Integrity iLO 2 supports an EFI utility to view or configure the iLO 2 MP LAN parameters. If the
parameters have not been previously configured, you can use this utility to set them from EFI.
To view the iLO 2 MP LAN parameters from EFI, follow these steps:
1. Boot to the EFI Shell.
2. Run ilosetup.efi from EFI.
fs0:\EFI\TOOLS> ilosetup get
Current LAN parameters:
IP Address : 15.255.96.44
Subnet
Gateway
To configure the iLO 2 MP LAN parameters from EFI, follow these steps:
1. Boot to the EFI Shell.
52 Getting Connected to iLO 2
51).
When DHCP is enabled, the system is vulnerable to security risks because
: 255.255.248.0
: 15.255.96.1
"Modifying User Accounts and Default
179).
Chapter 9: