Command Targets; Command Target Properties; Command Options; Level Option - HP Integrity BL870c Operation Manual

• version
• exit

Command Targets

The command target address identifies the specific managed element or association to be affected
by the command verb. All SM CLP commands have a command target, whether explicitly or
implicitly identified.
For instance, the target /map1/telnetsvc1/ can be identified in any of the following ways:
Using the target's absolute path:
</> hpiLO-> show /map1/telnetsvc1
Using the target's relative path form map1 target:
</map1> hpiLO-> show telnetsvc1
Using implicit (current) target's with the verb show
</map1/telnetsvc1> hpiLO-> show:

Command Target Properties

Target properties are identifying and descriptive information related to and defined by the target.
Target properties are identified by property names. Each class of target defines a set of valid
property names. Property values are expressed in name=value format.
You can specify one or more properties on the command line. If you specify multiple properties
on the same command line, they must be separated by a space.

Command Options

Command options control verb behavior.
Command options can appear immediately after the verb and must be prefaced with a dash (-).
Most command options have both a full name and a short form; for example:
show –level all or show –l all

Level Option

The level option instructs the command verb to include n number of levels in the scope of its
execution. A level typically refers to the depth of containment to be processed by the verb.
Forms:
-level <n>
-l <n>
Where n is the number of levels to include in command scope.
The value of n is interpreted as follows:
n=1 Verb is interpreted for the command target only (default).
n=2 Verb acts on the command target and any directly contained Managed Elements (MEs).
n=3 Verb acts on the command target, directly contained MEs, and any MEs contained by those
MEs (such as – current target and two down).
n=all Verb acts on the command target and all target MEs recursively contained in the command.
The following examples show command display option syntax:
Show information about default target and one level of contained MEs:
</>hpiLO-> show -l 2
Show all contained MEs:
</>hpiLO-> show -l all
156 Using iLO 2