Target: Map1/Dhcpendpt1; Target: Map1/Dnsendpt1; Ipendpt1 Properties; Dhcpendpt1 Properties - HP Integrity BL870c Operation Manual

Table 8-47 ipendpt1 Properties
Property Name
IPv4Address
SubnetMask
AddressOrigin
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
set Sets a property to a specific value.

Target: map1/dhcpendpt1

The dhcpendpt1 target represents the iLO 2 DHCP client.
Table 8-48 shows dhcpendpt1 target properties.
Table 8-48 dhcpendpt1 Properties
Property Name
EnabledState
OtherTypeDescription
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
start Enables iLO 2 DHCP.
stop Disables iLO 2 DHCP.

Target: map1/dnsendpt1

The dnsendpt1 target represents the iLO 2 DNS client.
Table 8-49 shows dnsendpt1 target properties.
168 Using iLO 2
Description
iLO 2 MP IP address.
iLO 2 MP subnet mask.
Indicates the configuration method
that resulted in the configuration being
assigned to this ipendpt.
Description
Represents the state of iLO 2
DHCP.
Textual description of this
protocol endpoint.
Access and Values
Read/write
The value of the property must be expressed
in dotted decimal notation.
Read/write
The value of the property must be expressed
in dotted decimal notation.
Read-only
The following are valid values:
Static: The iLO 2 MP IP address and subnet
mask were assigned statically.
DHCP: The iLO 2 MP IP address and subnet
mask were acquired using DHCP.
Access and Values
Read-only
The following are valid values:
Enabled: The iLO 2 DHCP client is enabled.
Disabled: The iLO 2 DHCP client is disabled.
Read-only
Set to DHCP.