Additional Setup; Modifying User Accounts And Default Password; Setting Up Security - HP Integrity rx2660 User's & Service Manual

Additional Setup

This section provides additional information to help you set up the iLO 2 MP.

Modifying User Accounts and Default Password

The iLO 2 MP comes preconfigured with default factory settings, including a default user account
and password. The two default user accounts at initial login are as follows:
• All Rights (Administrator) level user: login = Admin password = Admin
• Console Rights (Operator) level user: login = Oper password = Oper
NOTE:
IMPORTANT:
settings during the initial login session.
Make the following changes using any of the iLO 2 MP user interfaces.
To modify default account configuration settings, follow these steps:
1. Log in as the administrator. You must log in as the administrator in order to modify default
user configuration settings.
2. To modify default passwords, follow these steps:
a. Access the MP Main Menu.
b. Enter CM at the MP> prompt.
c. Enter UC at the MP:CM> prompt and follow the prompts to modify default passwords.
3. To set up user accounts, follow these steps:
a. Access the MP Main Menu.
b. Enter CM at the MP> prompt.
c. Enter UC at the MP:CM> prompt and follow the prompts to modify user accounts.

Setting Up Security

For greater security and reliability, HP recommends that iLO 2 MP management traffic be on a
separate dedicated management network and that only administrators be granted access to that
network. This not only improves performance by reducing traffic load across the main network,
it also acts as the first line of defense against security attacks. A separate network enables
administrators to physically control which workstations are connected to the network.
HP also strongly recommends that you modify the default settings during the initial login session
and determine the security access required and what user accounts and privileges are needed.
Create local accounts or use directory services to control user access. See
Accounts and Default Password" (page
User account and password are case sensitive.
For security reasons, HP strongly recommends that you modify the default
75).
Connecting and Setting Up the Console
"Modifying User
75