Pm: Power Regulator Mode - HP Integrity BL870c Operation Manual

CYCLE
Graceful Shutdown
Command line usage and scripting:
PC [ -on | -off | -graceful | -cycle ] [ -nc ]
-?
Example:
[gstlhpg1] MP:CM> pc -on -nc
PC -on -nc
System will be powered on.
-> System is being powered on.
-> Command successful.
[gstlhpg1] MP:CM>
See also: PR, PS

PM: Power regulator mode

Command access level: Power control access
PM provides the following options for remote control of the system power regulator:
Dynamic Enables the system to dynamically change the processor power level when needed
based on current operating conditions. The system remains in this mode unless the
system is reset or an OS-hosted application requests a processor state change. In
these cases, power management mode changes to OS Control Mode.
Low Sets the processor to the lowest supported processor state and forces it to stay in
that lowest state until the system is reset. If the processor is reset, the power mode
changes to OS Control Mode.
High Sets the processor to the highest supported processor state and forces it to stay in
that highest state unless the system is reset or an OS- hosted application requests a
state change. If the processor is reset, the power mode changes to OS Control Mode.
OS Sets the control of the power regulator to the OS.
Command line usage and scripting
Example
[gstl0074] MP:CM> pm
PM [ -dynamic | -low | -high | -os ] [ -nc ]
PM -?
[gstl0074] MP:CM> pm
PM
Current System Power Mode
Power Regulator Menu:
D - Dynamic Power Savings Mode
L - Static Low Power Mode
H - Static High Performance Mode
O - OS Control Mode
Enter menu item or [Q] to Quit: O
O
102 Using iLO 2
Turns the system power off, then on. The delay between off and on
is 30 seconds.
The BMC sends a signal to the OS to shut down prior to turning off
the system power.
: Dynamic Mode