Power Meter Readings Page - HP Integrity BL870c Operation Manual

Power meter readings is a licensed feature and requires the Advanced Pack license to see the
Power Regulator graphs from the iLO 2 web GUI. The license key also enables iLO 2 to share
information with Insight Power Manager.
NOTE:
You can obtain an instant power reading without a license key through the CLI using
the PS command.
The Power Meter Readings page has two sections: Power Meter Readings and 24-hour Power
History.
NOTE: Depending on your server, this page might look slightly different.
Figure 8-19 Power Meter Readings Page
NOTE:
The BL c-Class tab is available only on HP Integrity server blades.
IMPORTANT:
components, and levels of activity of the server at any given time.
Table 8-20 lists the fields, buttons, and descriptions.
Table 8-20 Power Meter Readings Page Description
Fields and Buttons
Power Meter Readings
Peak
Average
134 Using iLO 2
Power consumption data readings are dependent on the configuration, architecture,
Data is displayed using a bar graph. Each bar represents the power usage taken over
a five minute interval. Peak and average power usage are displayed by default. You
can display or hide peak, average, and minimum power samples by using the
appropriate checkbox. Samples are collected over a 24-hour period. Samples are not
retained over a management processor or server reset. Data can be displayed in Watts
or Btu/hr.
To display a tool tip that indicates the power usage, power regulator mode, temperature,
and timestamp, pause the mouse over the particular sample on the bar graph.
Displays the peak power reading from the server over the last 24-hour period.
Displays the average power reading from the server over the last 24-hour period.
Description