Table of Contents
Advertisement
Command line usage and scripting:
LS [ -nc ]
-?
See also: DNS, LC, SA
PC: Power control access
Command access level: Power control access
PC enables control of the power management module. It provides the following options for
remote control of system power:
ON
OFF
CYCLE
Graceful Shutdown
Command line usage and scripting:
PC [ -on | -off | -graceful | -cycle ] [ -nc ]
-?
Example:
[gstlhpg1] MP:CM> pc -on -nc
PC -on -nc
System will be powered on.
-> System is being powered on.
-> Command successful.
[gstlhpg1] MP:CM>
See also: PR, PS
PM: Power regulator mode
Command access level: Power control access
PM provides the following options for remote control of the system power regulator:
Dynamic
Low
High
OS
Command line usage and scripting
Turns the system power on. This command has no affect if the power
is already on.
Turns the system power off. This command is equivalent to turning
the system power off at the front panel switch. There is no signal sent
to the OS to shut the software down before power is turned off. To
turn the system off gracefully, ensure that the OS is shut down before
running this command.
Turns the system power off, then on. The delay between off and on
is 30 seconds.
The BMC sends a signal to the OS to shut down prior to turning off
the system power.
Enables the system to dynamically change the processor power level when needed
based on current operating conditions. The system remains in this mode unless the
system is reset or an OS-hosted application requests a processor state change. In
these cases, power management mode changes to OS Control Mode.
Sets the processor to the lowest supported processor state and forces it to stay in
that lowest state until the system is reset. If the processor is reset, the power mode
changes to OS Control Mode.
Sets the processor to the highest supported processor state and forces it to stay in
that highest state unless the system is reset or an OS- hosted application requests a
state change. If the processor is reset, the power mode changes to OS Control Mode.
Sets the control of the power regulator to the OS.
Text User Interface
75
Advertisement
Table of Contents
