Specifying Group Properties - Cisco CISCOWORKS COMMON SERVICES 3.0 User Manual

Chapter 5 Administering Groups
Step 2

Specifying Group Properties

Step 1
Step 2
78-16571-01
From the groups listed in Group Selector, select the group under which you want
to create the new group.
The group you select here is the parent group for the new group you are about to
create.
You can create a new group only under User Defined Group.
The default limit of User Defined Groups you can create is 100. If you try to create
more than 100 User Defined Groups, you will get a message saying that you have
exceeded the limit.
The Group Info fields on the right pane display details of the selected group.
You can change the parent group later, if required.
The following tasks have to be performed:
Specifying Group Properties
1.
Defining Group Rules
2.
Assigning Group Membership
3.
While creating a new group you must complete all the three tasks in this sequence
to create a group.
If you exit the wizard at any stage by clicking Cancel, the details you have
specified will be lost and the group will not be created.
While specifying group properties, you can enter the properties such as name and
description, and modify the parent group, if required, and update membership,
and specify the visibility scope.
To complete the tasks in this phase:
In the Group Administration and Configuration dialog box, click Create.
In Properties:Create dialog box, enter a name for the group in the Group Name
field.
The group name should be unique within the parent group. However, it need not
be so across groups. The same group name cannot be used in the same group
hierarchy.
User Guide for CiscoWorks Common Services
Group Administration
5-15