Cisco CISCOWORKS COMMON SERVICES 3.0 User Manual page 210

Enabling Debugging Tools
From the Functions Available pane, click SNMP Walk.
Step 3
The SNMP Walk dialog box appears.
Enter the IP address or DNS name.
Step 4
For SNMP Version 1 and 2c (if it is a 64-bit counter, use SNMP v2):
Step 5
•
•
•
•
For SNMP Version 3:
•
•
•
•
•
The fields are case sensitive.
Click OK to get the results.
Step 6
The results will be based on the parameters you entered. When the walk is
complete, you can save it as text. A full walk may take a long time.
If you launch SNMP Walk feature with Network Operator/Help Desk privilege,
device credential fetching fails and the fields of read/write community strings of
SNMP v1/v2c, read/write SNMPv3 credentials are set to default values.
You have to manually enter SNMP v1/v2c/v3 credentials.
User Guide for CiscoWorks Common Services
6-10
Enter the Read community string.
Enter the starting OID (optional). If this field is left blank, the tool will start
from 1.
Enter the SNMP Timeout.
Select the check box to get output OIDs numerically.
Provide the SNMPv3 Username and password
Specify the SNMP v3 Auth Protocol. Select either the MD5 radio button or
the SHA radio button.
Enter the starting OID (optional). If this field is left blank, the tool will start
from 1.
Enter the SNMP Timeout. The default is 10 seconds.
Select the check box to get output OIDs numerically.
Chapter 6 Using Device Center
78-16571-01