Table of Contents
Advertisement
Setting Up the Chassis
Setting Up the Chassis
You can set the chassis on a desktop or install it in a rack. Use the procedure in this section that best
meets the needs of your network:
•
•
When installing the unit, the ground connection must always be made first and
Warning
disconnected last. To see translations of the warnings that appear in the publication,
refer to the Regulatory Compliance and Safety Information document that accompanied
this device.
This unit is intended for installation in restricted access areas. A restricted access area
Warning
is where access can only be gained by service personnel through the use of a special
tool, lock and key, or other means of security, and is controlled by the authority
responsible for the location. To see translations of the warnings that appear in the
publication, refer to the Regulatory Compliance and Safety Information document that
accompanied this device.
Setting the Chassis on a Desktop
The location of the chassis is extremely important for proper operation. Equipment placed too close
together, inadequate ventilation, and inaccessible panels can cause malfunctions and shutdowns, and can
make maintenance difficult. The following information will help you to plan the location of the chassis:
•
•
Attach the rubber feet as shown in
with your universal gateway.
Cisco AS5400 Universal Gateway Chassis Installation Guide
3-2
Setting the Chassis on a Desktop
Rack-Mounting the Chassis
Plan for access to both front and rear panels of the chassis.
Ensure that the room where the chassis operates has adequate ventilation. Remember that electrical
equipment generates heat. Ambient air temperature may not cool equipment to acceptable operating
temperatures without adequate ventilation.
Chapter 3
Installing the Cisco AS5400 and Cisco AS5400HPX Universal Gateways
Figure
3-1. Rubber feet are included in the accessory kit that shipped
OL-2847-02 0A
Advertisement
Table of Contents
Troubleshooting
