Enabling Host-Based Eap - Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual

Enabling Host-Based EAP

Figure 5-8
Enter your username, password, and server name for your certificate server, which can be obtained from
Step 3
your system administrator, in the appropriate fields.
Tap the Enroll button. The box at the bottom of the screen indicates the status of the certificate
Step 4
enrollment by changing from Ready to Processing.
If the operation is successful, the following message appears: "A certificate has been added to your
device."
Step 5 Tap OK to close the Certificate Enrollment screen.
Enabling Host-Based EAP
Follow these steps to enable host-based EAP authentication (EAP-TLS or PEAP) for this profile on a
PPC 2002 device.
Because EAP-TLS and PEAP authentication are not enabled in ACU, you cannot switch between these
Note
authentication types simply by switching profiles in ACU. You can create a profile in ACU that uses
host-based EAP, but you must enable the specific authentication type in the Authentication Manager. In
addition, only one authentication type can be set at a time; therefore, if you have more than one profile
in ACU that uses host-based EAP and you want to use another authentication type, you must change the
authentication type in the Authentication Manager after switching profiles in ACU.
Step 1 From the Properties screen, select Network Security Type under Property and Host Based EAP from
the list of options in the Value box.
Step 2 Select WEP under Property and Dynamic WEP Keys from the list of options in the Value box.
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
5-28
Certificate Enrollment Screen
Chapter 5 Configuring the Client Adapter
OL-1375-04